Building In The Dishwasher; Measurements - Miele G 307 Operating Instructions Manual

Installation
Installation
This dishwasher is intended to be built
into a tall unit.
The following are needed:
– A facia panel (GW...)
– A dishwasher front, consisting of
panel front and plinth facia (GFH 55)
– A building in frame (GER 60).
The facia panel and the front panel must
be fitted before the dishwasher is built
into the tall unit .
To ensure stability this dishwasher
must only be built into a tall unit. It
must not be set up as a freestand-
ing machine.
The tall unit should be secured to
the wall for stability with the bracket
supplied.
50
1. Measurements for building in
The following conditions must be met:
– The recess floor must be capable of
bearing a load of at least 80 kg
– The height of the dishwasher from
the base of the floor will depend on
the onsite water inlet connection
(see section on "Plumbing").
– The cabinet / space into which the
dishwasher is being built must be at
least 550 mm deep.
– An installation opening (from base of
the recess to floor) must be a mini-
mum of 50 mm deep and 100 mm
wide.
.