Time Display; At The End Of A Programme - Miele G 1272 Operating Instructions Manual

Time display

The duration of the programme
selected appears in hours and minutes
in the Time display before the
programme begins. During the
programme, the time left until the end of
the programme is displayed.
The time displayed may vary with the
same programme. This can be due to
the water temperature at each intake,
the reactivation cycle, the amount of
crockery and how dirty it is.
When a programme is selected for the
first time, the display shows an average
time for a cold water intake.
The times shown in the Programme
chart refer to standard test loads and
temperatures.
Each time a programme is run, the
electronic unit adjusts the programme
duration according to the amount of
crockery and the temperature of the
incoming water.
To save energy, the time display goes
out after a few minutes if you do not
press any buttons during this time.
Press any button (apart from the Off
button V) to switch the time display
back on again.

At the end of a programme

At the end of a programme, the
In-operation indicator light will be
visible flashing slowly with the door
shut.
When the door is opened a "0" will
appear in the Time display.
You can now empty the dishwasher.
The In-operation indicator light will go
out one hour after the end of the
programme.
,
To prevent the risk of steam
damage to the worktop edging
above the dishwasher, it is
advisable to leave the door closed
until you are ready to unload the
crockery. Alternatively you can open
the door fully until the crockery is
cool enough to unload. Do not leave
the door only partially open.
Operation
35