Salt Indicator - Miele G 1102 SCi Operating Instructions Manual

Before using for the first time
^ Remove the lower basket and
unscrew the salt reservoir cap.
Only open the salt reservoir when
you want to fill it with dishwasher salt
as water or salt solution will run out
of the reservoir when the cap is
removed.
^ Fill the reservoir with approx. 1 litre of
water (first use only).
^ Place the funnel provided over the
salt reservoir and carefully fill with
salt until the reservoir is full. The salt
reservoir holds approx. 1 kg of salt
depending on the brand used.
^ Clean any excess salt from around
the reservoir opening and then screw
the cap on again firmly.
^ Run the Quick wash programme
immediately (without any crockery in
the dishwasher) to remove any traces
of salt from the cabinet.
18

Salt indicator

^ Fill the salt reservoir with dishwasher
salt when the salt indicator light
comes on. (If it comes on during a
programme, wait until the end of the
programme).
After the reservoir has been filled, the
water softener is automatically
reactivated the next time the
dishwasher is run. The salt refill
indicator may still be illuminated during
this process. It will go out once the salt
concentration has reached the correct
level.
The salt refill indicator will not come on
if the dishwasher has been
programmed for a water hardness level
of less than 0.7 mmol/l (4°d, German
scale).
,
After refilling the salt reservoir,
run the Quick wash programme im-
mediately (without any crockery in
the dishwasher) to remove any
traces of salt from the cabinet.