Related Manuals for Miele S 858
Summary of Contents for Miele S 858
-
Page 1: Operating Instructions
Operating instructions Vacuum cleaners S 758 S 858 These operating instructions apply to standard models S 758 / S 858 as well as to other models which are distinguished by names rather than numbers. M.-Nr. 05 783 463... -
Page 2: Table Of Contents
Contents Caring for the environment Description of the appliance Warning and Safety instructions Preparing for use Accessories supplied Using the accessories supplied Crevice nozzle ........... . 16 Crevice nozzle extension . -
Page 3: Caring For The Environment
Caring for the environment Disposal of packing material Disposal of your old appliance The transport and protective packing Electrical and electronic appliances has been selected from materials which often contain materials which, if are environmentally friendly for disposal handled or disposed of incorrectly, and can normally be recycled. -
Page 4: Description Of The Appliance
Description of the appliance... - Page 5 Description of the appliance a Hand piece b Plus / Minus buttons for setting the suction power c Electrobrush switch d Locking button e Electro-telescopic tube release button f Electro-telescopic tube g Dust compartment lid catch h Dust compartment filter (for motor protection) i Dustbag j Electrobrush (SEB 217 or SEB 236, depending on model) k Carrying handle...
-
Page 6: Warning And Safety Instructions
Warning and Safety instructions Before using for the first time This appliance meets statutory Check the packaging, the vacuum safety requirements. To avoid the cleaner and accessories for any risk of injury or damage to the signs of damage. Do not use a appliance you should read these damaged appliance: it could be operating instructions carefully... - Page 7 Warning and Safety instructions There is a metal inlay underneath Floor attachments, accessories the handle, which is designed to and tubes must not be used at protect the user from electrostatic head level to avoid the risk of injury, discharges. Please make sure that you e.g.
-
Page 8: Using Accessories
If the cable is damaged it should re-use. Blocked pores reduce the be replaced together with a efficiency of the cleaner. complete cable rewind by a Miele ser- Use only Miele approved vice technician. dustbags, filters and accessories. This will ensure optimum performance... -
Page 9: Preparing For Use
Preparing for use Attaching the suction hose ^ Open the dust compartment shutter The dust compartment shutter is designed for hygienic handling and prevents dust and odours escaping. If you remove the suction hose from the vacuum cleaner for storage purposes close the dust compartment shutter before putting the cleaner away (e.g. - Page 10 Preparing for use Connecting the suction hose and the suction tube ^ Fit the hand piece of the suction hose into the suction tube. (Ensure that the plug connectors line up). They must lock together with a click. ^ To release the hand piece from the suction tube press the locking button (see arrow) and pull the hand piece away from the suction tube.
-
Page 11: Using The Electrobrush
Preparing for use Using the Electrobrush The Electrobrush is particularly suitable for intensive vacuuming of carpets which are subject to hard wear. It is very effective at removing deep seated dirt and preventing areas of frequent use being trodden into a path. It is also important to observe the flooring manufacturer’s cleaning and care instructions. -
Page 12: Vacuum Cleaner
Preparing for use Fitting the Electrobrush to the vacuum cleaner ^ Insert the electro-telescopic tube into the Electrobrush. (Ensure that the plug connectors line up). They must lock together with a click. For further information on use and maintenance please refer to the separate instructions supplied with the Electrobrush. -
Page 13: Accessories Supplied
It can also be used with the brush protruding to vacuum hard flooring. For hard flooring, such as stone and parquet, we recommend using one of the special Miele floor brushes (see "Accessories available as optional accessories). It is also important to observe the flooring manufacturer’s cleaning and... - Page 14 Accessories supplied Parquet floor brush (standard or optional accessory depending on country) This brush has natural bristles and is designed for use on parquet floors and other surfaces which are susceptible to scratching such as laminate flooring. Other tools, in addition to the floorhead(s), are supplied with the vacuum cleaner to help deal with various types of cleaning.
- Page 15 ^ Press the release button to open the accessories compartment lid. ^ Take out the accessory you require. ^ Press down firmly on the lid to close S 858 accessories compartment The extension for the crevice nozzle is located in the compartment underneath the crevice nozzle.
-
Page 16: Using The Accessories Supplied
Crevice nozzle For cleaning in folds, crevices or corners. Crevice nozzle extension (only for S 858) This accessory can be used to extend the length of the crevice nozzle. Further length is provided by pulling out the inner section. -
Page 17: Dusting Brush
Using the accessories supplied Dusting brush For cleaning skirting boards, ornate or carved articles, etc. The head of the dusting brush can be swivelled to attain the best cleaning position. Upholstery nozzle For cleaning upholstery, mattresses, cushions, curtains, covers etc. -
Page 18: Operation
Unwinding ^ Hold the plug and unwind the cable to the required length: max. approx. 6.5 m (S 758) or 8.5 m (S 858). If vacuuming for longer than 30 minutes, the mains cable must be pulled out to its fullest extent. -
Page 19: Switching On And Off
Operation Switching on and off To switch the vacuum cleaner on: ^ Press the On-Off switch. The Stand-by indicator light comes on to show that the vacuum cleaner is ready for use. To switch the vacuum cleaner off: ^ Press the On-Off switch again. The Stand-by light goes out. -
Page 20: Regulating The Suction
Operation Regulating the suction ^ Switch the machine on. Use the p and m on the hand-piece to regulate the suction to suit the type of flooring. The power setting selected is shown on the handle. Setting 9 = no suction Low setting = weak suction High setting = strong suction The symbols on the controls of your... -
Page 21: Blowing Out
Operation Blowing out Blower connection socket (optional accessory for S 758) The blower connection socket can be used to connect the suction hose to the "blower" outlet of the vacuum cleaner, e.g. for dusting off multi-layered radiators and blowing dust out of inaccessible corners so that it can be vacuumed up. -
Page 22: Setting Down, Transportation And Storage Park System
Setting down, transportation and storage Park system A Park system has been designed for conveniently parking the vacuum cleaner during pauses. A special parking attachment is fitted to all floorheads, including the SEB 217 Electrobrush (but not the SEB 236 Electrobrush as this can be parked independently), and to the rear of the cleaner. -
Page 23: Transportation And Storage
Setting down, transportation and storage Transportation and storage ^ Stand the vacuum cleaner upright when it is not being used and during storage. ^ On the SEB 217, fit both clips on the Electrobrush into the two point holder on the side of the cleaner. This does not apply to the SEB 236, which can stand independently. -
Page 24: Maintenance And Care
You can replace the "ACTIVE HEPA" your warranty and cause damage to exhaust filter with one of the other Miele your product. exhaust filters if you wish (see "Replacing one type of filter with... -
Page 25: When To Change The Dustbag
When to change the dustbag Change the dustbag when the colour marker in the dustbag change indicator fills the display. Miele vacuum cleaner bags are disposable and intended to be used only once. Do not attempt to re-use as suction would be reduced. -
Page 26: Replacing The Dustbag
Maintenance and care Replacing the dustbag ^ Press the release button for the dust compartment lid and raise the lid as far as it will go. ^ To remove the dustbag hold the bag by the collar and pull it out of its holder. -
Page 27: When To Change The Exhaust Filter
You can replace the ACTIVE HEPA exhaust filter supplied with the vacuum cleaner with one of the other Miele exhaust filters if you wish (see "Replacing one type of filter with another"). -
Page 28: Replacing The "Active Hepa" Filter
Maintenance and care Replacing the "ACTIVE HEPA" filter ^ Open the dust compartment lid. ^ Release the catch and remove the filter. ^ To insert the new filter, fit it so that it engages at the back and then close the catch. -
Page 29: Replacing One Type Of Filter With Another
Maintenance and care Replacing one type of filter with another You can replace the ACTIVE HEPA Filter c supplied with your vacuum cleaner with one of the following exhaust filters: a a SUPER air clean filter or b an ACTIVE air clean filter The ACTIVE air clean filter is fitted in the same way as the ACTIVE HEPA filter. -
Page 30: When To Change The Dust Compartment Filter (Motor Protection)
Replace the dust compartment filter every time you start a new packet of dustbags. A dust compartment filter is supplied with every packet of Miele dustbags. To replace the dust compartment filter ^ Open the dust compartment lid. ^ Unclip the filter frame, remove the old filter and replace with a new one. -
Page 31: When To Change The Thread Lifters
(bayonet connection) and pull out the pin. b Take out the roller. Remove all threads and hair etc, then replace the individual parts in the correct order. Spare parts are available from your Miele dealer or from the Miele Spare Parts Department. -
Page 32: Cleaning And Care
E-Cloth A microfibre "E-Cloth" is available from the Miele UK Spare Parts Department, Part Number 98013530, which is suitable for cleaning surfaces such as stainless steel, glass, plastic and chrome without the use of chemicals. It can be washed 300 times. -
Page 33: Problem Solving Guide / After Sales Service
It can then be switched on again. After Sales Service In the event of a fault that you cannot easily remedy, please contact – your Miele Dealer, or – the Miele Service Department (see back cover for contact details). When contacting your Dealer or the... -
Page 34: Accessories Available As Optional Extras
Accessories available as optional extras Certain models are supplied as standard with one or more of the following accessories: Important: please observe the flooring manufacturer’s cleaning and care instructions. Turbobrush The Turbobrush is particularly suitable for vacuuming cut pile carpeting. The brush is operated by the suction power of the vacuum cleaner. - Page 35 Accessories available as optional extras Hard floor brush This brush is designed for use on hard flooring such as tiled or stone floors. Parquet floor brush This brush has natural bristles and is designed for use on parquet floors and other surfaces which are susceptible to scratching such as laminate flooring.
- Page 36 Accessories available as optional extras Crevice nozzle (300 mm) For cleaning in folds, crevices or corners. Radiator brush (can only be used if attached to the crevice nozzle) For cleaning radiators, narrow shelves and crevices. Universal brush For dusting books, shelves, etc.
- Page 37 Accessories available as optional extras Dusting brush with natural bristles This brush is suitable for particularly delicate objects. Mattress nozzle For cleaning upholstery, mattresses, cushions, curtains, covers etc. MicroSet This set is specially designed for cleaning small objects and difficult to reach areas (such as PC keyboards, stereo equipment, intricately carved furniture and ornaments, models etc).
- Page 38 Accessories available as optional extras CarClean Set Plus The CarClean Set Plus has been designed as an accessory for Miele cylinder vacuum cleaners for valeting the interior of cars. It consists of: – Hand-held Turbobrush – Micro-hose with combination nozzle (crevice nozzle and dusting brush) –...
-
Page 39: Electrical Connection For The Uk
Electrical connection for the UK All electrical work should be carried out by a suitably qualified and competent person in strict accordance with national and local safety regulations. The voltage and connected load are given on the data plate located underneath the vacuum cleaner. - Page 40 Alteration rights reserved / (S 758 / S 858) - 3705 M.-Nr. 05 783 463 / 01 en - GB...