Power Cut - Miele KM 83-2 Operating Instructions Manual

Burners
Burners
Press in the correct control knob and
turn anti-clockwise to the high set-
ting (large flame symbol).
When the flame ignites keep the button
pressed in for 5-10 seconds, and
then press down once more firmly
before letting go.
If the flame goes out, repeat the procee-
dure, keeping the control knob pressed
in for a few extra seconds.
If after several attemps the gas still
does not burn, check whether the
knobs of the burner cap are correctly
positioned in the notches in the burner
head.
Turn the control knob to:
the highest setting for boiling or searing
food, the low setting for continuing
cooking and for keeping food warm.
10
Turn the control knob down to a low set-
ting in good time in order to prevent
food boiling over or burning.
To switch the burner off turn the con-
trol knob in a clockwise direction to
the "X" position.
The flame will go out.

Power cut

If there is an interruption to the elec-
tricity supply, the gas can be ignited
with a match.
Press in the burner control and turn
anti-clockwise to the highest setting,
(large flame).
With the control knob pressed in,
ignite the gas at the burner with a
match.
Keep the control knob pressed in for
a further 5-10 seconds, and then
press firmly down once again before
letting go.
Important:
When using the burners:
ensure that there is a minimum dis-
tance of 50 mm between the pan
and a heat-sensitive worktop or sur-
round.
After combustion the hot gases flow
outwards under the base of the
pan, and may consequently burn
the edge of the worktop or surround
if too close.