Miele KM 530 Operating And Installation Manual page 45

... the food in the pan hardly heats up
or does not heat up at all when the
Auto heat-up function is switched on
This could be because:
– there is too much food in the pan.
– the pan is not conducting heat
properly.
Select a higher continued cooking
setting next time, or start cooking at the
highest setting and then turn down to a
lower setting manually later on.
... it seems to take too long for a pan
of food to reach the required
temperature
See "To test the power level".
... one or more residual heat
indicators are flashing
– There was an interruption to the
power supply during operation, and
the hob has switched itself off.
The hob can be used again as normal.
Check the cooking stage of the food
and whether its condition has been
affected by the power failure before
switching the cooking zone(s) back on
again.
– The residual heat indicators have lit
up during programming.
Problem solving guide
... the sensors are over-sensitive or
do not react at all, or the safety lock
indicator and cooking zone display
numbers light up when the hob is
switched off
The sensitivity level of the sensors has
altered and cannot recalibrate
automatically.
Proceed as described in "Automatic
recalibration of the sensor switches".
If this does not solve the problem,
please call the Miele Service
department.
... the outer area of a cooking zone
that has just been switched on glows
faster and more intensely than the
inner area
That is not a fault: the cooking zone is
fitted with two different elements (see
"Guide to the appliance - Cooking
zones").
... an F appears in the display for the
rear cooking zones, an E appears in
the display for the front cooking
zones and numbers appear in the
timer display
Interrupt the power supply to the hob
for approx. 1 minute.
If the problem persists after
reconnecting the appliance to the
power supply, please contact the Miele
Service department.
45