Advertisement
(Standard wall unit 60 cm wide)
The side spacers cover the gaps be-
tween the sides of the appliance and
the wall unit.
Before fitting the side spacers, use a
knife to make a cut-out in the side
spacer for the appropriate side of
the wall unit to accommodate the
wall unit hingeing.
Screw the side spacers to the hous-
ing with 3.5 x 9.5 mm screws and
press them in at the sides.
Exception: Please refer to the notes
under "Special fitting instructions" at
the end of the "Installation" section for
instructions on fitting the appliance into
a wall unit with 19 mm thick carcase
sides or into a 70 cm or 90 cm wide
wall unit.
30
Measure the gap "T" to be covered
between the rear of the appliance
and the wall.
Use a knife to trim the spacer strip
supplied to measurement "T".
Stick the spacer strip to the under-
side of the appliance.
Turn the side cover caps upwards
and press into position.
Hide quick links:
Advertisement
