M-Audio Session KeyStudio Quick Start Manual page 5

|
4
Installation and Setup Overview for Windows XP
It is important that installation and setup take place in the following sequence (all of
these steps are explained in detail below):
1. Connect the KeyStudio USB MIDI keyboard to your computer and turn it on.
2. Install the Session music creation software. This software enables support for
the M-Audio Micro USB audio interface, and must be installed before the Micro
is connected.
3. Connect the M-Audio Micro USB audio interface. This device not only serves as
a high performance USB audio interface, but also as the copy protection key for
Session. Micro must be connected for Session to launch.
Connecting the KeyStudio Keyboard to your PC
1. Use the provided USB cable to connect KeyStudio to an available USB port on
your computer. The USB cable not only powers the keyboard but also transmits
MIDI data to your computer.
2. Make sure that the power switch on the back of the keyboard is in the "on" ( I )
position. KeyStudio is now ready to be used – no additional installation steps
are required.
Installing the M-Audio Session Software
PLEASE NOTE: Do not connect your M-Audio Micro audio interface to your computer until
the Session software has been installed. Leave your Micro disconnected until instructed to
connect it.
1. Insert the M-Audio Session
DVD-ROM into your computer's
DVD-ROM drive.
2. The computer will automatically
display the install screen
your computer fails to launch the
installer, manually start it by clicking
on Start>My Computer>Session.
Session KeyStudio Quick Start Guide
. If
1
1