Advertisement
1260USB setting to be what you like:
1. Under Windows environment, to check
USB simulation COM port, see which
port can be assigned.
2. Make sure 1260USB has already set to
RS232 interface. If you are using
1260USB as keyboard simulated
interface, close "Card Manager" to set
this 1260USB back to the RS232
simulated status.
• Note: 1260USB creates system an
additional virtual COM port with a number
which behind your current COM ports.
After the 1260USB driver installed, you
are advised to go to windows operation
system "Device Manager" to check USB
simulated COM port (See figure 2-2). You
have to know which COM port number in
hardware was assigned for your simulated
Keyboard or RS232 interface. So that, you
can refer it to your application and make
sure it being used by correct COM port
number.
Due to the COM port assignment;
remember to close "card manager" Before
running "1260U programming tool"
13
Advertisement
