Janome 1200D Instruction Book page 71

(b)
(c)
(a)
THREAD ROUTE
BROWN (H) (for 5-thread and chain stitch)
To thread the Chain Looper
Hand turn the handwheel to bring the needle bar to its
lowest position. Lift up the lever (a) to disengage the
chain looper. Hook the thread into the slit (b) from back
to front. Pull the thread along the looper and pass the
thread from front to back through the hole (c) on far left
end of looper. Leave about 5 cm (2") of thread hanging
down. Hand turn the handwheel to bring the needle bar
to its highest position and the chain looper is
automatically engaged.
Important:
Be sure to pass the thread under the thread guide (d)
next to the take-up lever.
70
d