Honeywell S7999B Product Data page 43

Statistics Status
Table 53 displays the statistics status page data for the
R7910A or R7911. Though the Steam control will not have a
pump, the output can be used to run some other auxiliary
equipment.
Table 53. Control Statistics Status.
Data
Burner cycles Number of cycles
Burner run time Duration of run time
CH pump cycles Number of cycles
System pump cycles Number of cycles
Controller cycles Number of cycles
Controller run time Duration of run time
The bar graph displayed for this status is the outlet sensor
temperature.
Fig. 86. Control Statistics Status menu (top).
Fig. 87. Control Statistics Status menu (bottom).
Comment
43
S7999B, S7999C SOLA LOCAL OPERATOR INTERFACE
Stack Limit Status
Table 54 shows the status page data for the control Stack Limit.
Table 54. Stack Limit Status.
Data
Stack limit enable Enabled or Disabled
Stack limit Temp setting between -40 °F to 266 °F
(-40 °C to 130 °C)
Stack limit setpoint Temp setting between -40 °F to 266 °F
(-40 °C to 130 °C)
Stack sensor state None, Normal, Open, Shorted,
Outside high range, Outside low
range, Not reliable (None=no stack
temp sensor)
Stack temperature Stack sensor temperature (same as
bar graph)
The bar graph displayed for this status is the stack sensor
temperature.
Fig. 88. Stack Limit Status menu.
Lead Lag Slave Status - Hydronic
Only
Table 55 shows the status page data for Lead Lag Slave.
Table 55. Lead Lag Slave.
Data
Type Slave
Command Received Yes/No
Demand Off
Request Rate RPM
Burner Control Standby
Modulating No
Priority
Comment
Comment
65-0303—05