Care And Cleaning - Wolfgang Puck BFAL0010 Bistro collection Manual

Care & Cleaning
After each use it is important that you properly clean your new Saucier.
You should rinse the pitcher in cold water prior to using. In addition, the
following guidelines should be adhered to:
Care of the Base Unit
1 ALWAYS unplug the base unit prior to cleaning and .After each use,
clean with a warm damp cloth or sponge and dry with a soft towel.
This is especially important around the switch and center drive
assembly to prevent buildup of spilled ingredients.
Care of the Pitcher and Paddles
1 Never immerse the Pitcher in water. The lower surface of the Pitcher
must be dried before use.
2 The Pitcher should never be placed in an automatic dishwasher!
3 Immediately after each use, the Pitcher, Paddles, Lid with Splash
Guard, and Flavor Hatch should be carefully washed with warm
soapy water using a sponge or scrubber pad. Rinse with and dry
with a soft towel.
4 If washing needs to be delayed, then a small amount of warm water
should be placed in the Pitcher to soak. The water helps prevent the
buildup of ingredients on the stainless steel surface and makes
cleaning easier. Clean and dry as above when ready.
5 Prior to use and between consecutive cycles, the appliance should
be rinsed with water to insure proper operation.
6 Occasionally, it is recommended that the Saucier be operated with
1 1/2 cups of water and a small amount of non-sudsing detergent.
7 Care should be taken when cleaning smaller parts, such as the Flavor
Hatch, to avoid accidentally dropping in the garbage disposal or
discarding in the trash.
Assembly and Cleaning of the Paddles
Your Saucier includes three paddles: the Froth Paddle, the Sauce Paddle,
and the Cream Paddle. Each paddle can be disassembled into three
elements to facilitate thorough cleaning (See Figure On Page 12). There is
one common shaft and three sets of whipping paddles. The Froth Paddle
utilizes the gray set of blades; the Sauce Paddle utilizes the black set, and
the Cream Paddle utilizes the white set.
11
Care & Cleaning (continued)
Assembly
To assemble the desired paddle, hold the bottom
section of the Shaft (C) with one hand and with the
a
other hand, slide the Bottom Blade (longer barrel)
(B) over the knob and onto the Shaft and press firmly
into place. Then slide the Top Blade (shorter barrel)
b
(A) over the knob and onto the shaft.
Push down until it locks into position.
Cleaning
1 To clean desired Paddle, hold the Bottom Blade
(B) with one hand and with the other hand, pull
and remove the Top Blade (A) from the Shaft (C).
c
Then pull and remove the Bottom Blade (B) from
the Shaft (C).
2 Wash the three parts with warm soapy water
using a sponge and then dry with a soft towel.
3 To reassemble, follow the Assembly instructions
above.
12