Advertisement
1. Set up at least two Monster PowerNet devices according to the initial
setup instructions, and ensure that they are receiving power.
2. Press and hold the PLC security Sync button on the bottom of one
PowerNet for approximately ten seconds until the Power/Security LED
light on the front of the device flashes. Then release the button.
3. Repeat Step 2 for the second PowerNet device. The security key has been
erased from both PowerNet devices. They must now be re-linked to reset
a new key.
note: You have 2 minutes to link PowerNet devices before they revert
to normal operating mode.
4. P ress and hold the PLC Security Sync button on one PowerNet device
for 2 seconds until the Power/Security LED light flashes.
5. R epeat Step 4 for the other PowerNet device.
6. A fter a few seconds the Power LED flashing will stop, indicating they
have been linked together with a new security key.
11
ADDInG More PoWerneT
™
To add a third (or more) PowerNet devices to a private network:
1. Press and hold the PLC Security Sync button on the bottom of the new
PowerNet device for approximately ten seconds until the Power/Security
LED light flashes. Release the button. The security password has been
erased from the new PowerNet device. It must now be linked to your
network to adopt the new network security key.
2. Again, press and hold the PLC Security Sync button on the bottom of the
new PowerNet device, this time for two seconds. The Power/Security
LED light will begin to flash.
3. Press and hold the PLC security/sync button on the bottom of any other
PowerNet device that is already linked to the network for two seconds.
The Power/Security LED light will begin to flash.
4. T he new PowerNet device will now automatically link to the network
using the new security key. The Power/Security LED light will stop
flashing indicating a successful link.
seTuP TIP
If you are connecting more than two Monster PowerNet devices, or you plan
to link two PowerNet devices that are in remote rooms of your home, you can
link them together by plugging them into AC outlets that are close to each
other or in the same room. Link them following the above instructions,
then move them to the wall outlets where you want to use them.
DevICes
12
Advertisement
