Southbend StratoSteam STRE-3D Owner's Manual page 23

S S E C
TRATO TEAM LECTRIC
Figure 12
Steamer Not Heating Up Properly or Not Cooking Properly, "Power" Light is Lit
Check that water-supply pressure is adequate.
DISCONNECT POWER AT CIRCUIT BREAKER
Check door switch (see page 29).
Door switch OK?
No
Replace door switch.
Reconnect door switch lead wires.
Check water solenoid (see page 32).
Water solenoid OK?
No
Replace water solenoid.
O '
WNER S
S
OUNTERTOP TEAMER
Steamer not heating properly or not cooking properly,
No Switch in COOK MODE?
Set switch to
COOK MODE.
Turn off steamer and check that it drains completely. If steamer
does not drain, check drain path for obstructions. Turn steamer
back on and wait 10 minutes.
No
Check for loose or broken
wires (see wiring diagram).
If wiring is OK, remove screen
from strainer and clean or
replace as necessary.
Reassemble, reconnect, and
recheck the steamer. If water
still does not enter the
steamer, examine the water
solenoid and inline Y strainer
for obstructions or deposits.
Clean or replace as
necessary.
Check Cook-Idle Switch for
proper operation.
M 1189951 (10/08)
ANUAL
"Power" light is lit.
Is water level at
normal level in cavity?
DISCONNECT POWER AT CIRCUIT BREAKER
Check high-limit thermostats (see page 30).
No
Yes
Replace high-limit
thermostats as necessary.
Check resistance between heating-cartridge contactor terminals
and replace heating cartridges as necessary (see page 25).
Check water-level control sensor (see page 31).
Yes
No
Replace water-level
control sensor.
No
Replace contactor.
Yes
Yes
High-limit thermostats OK?
Water-level control
sensor OK?
Check contactor (see page 27).
Contactor OK?
Check for loose or broken
wires (see wiring diagram).
If wiring is OK, check that
heating cartridges are secure
(tighten to 75 inch-pounds of
torque).
S
ERVICE
Yes
Yes
Yes
P 23 56
AGE OF