Page 1
PRODUCT SUPPORT MANUAL RCL-100D // Remote Control Searchlight System Model No.: RCL-100D Product No.: 1930.3, 1931.3 Y1-03-0138 Rev. U Y1-03-0138U...
Searchlight. The combination of computer aided design, high quality raw materials, and quality-controlled manufacturing produce a superior product. The Test Facility at ACR can reproduce some of the harshest environmental conditions known to man. This assures that the products we produce can stand up to the tough marine environment.
SECTION 2 - GENERAL The RCL-100D was specially designed for mariners who require a high intensity remote controlled searchlight that can stand up to the tough marine environment. The RCL-100D Searchlight System contains a narrow beam searchlight that produces 200,000 peak candle power by combining two 55W halogen lamps with our unique optical quality parabolic reflectors.
NOTE: The Searchlight should be left uncovered if the XRCiZ feature is enabled. SECTION 4 - REMOTE CONTROL SYSTEM The Remote Control System consists of the URC-102 Master Controller and the URP-102 Point Pad™. This system is compatible with 12 VDC and 24 VDC systems without modification. The Remote Control System may be used with 12 V or 24 V Searchlights, ONLY THE LAMPS IN THE LIGHT HEAD ASSEMBLY MUST BE CHANGED TO MATCH THE VOLTAGE RATING.
Page 6
“F” connectors to the Master Controller and the Point Pad™. The cable and connectors are available either through ACR Electronics, your local Radio Shack or other sources of electronic hardware. Additional Point Pads™ (up to three (3) Pads) may be used with one (1) Master Controller.
Page 7
URC-102 URC-102 Master Master Controller Unit Controller Unit RG-59 Coaxial Cable RG-59 Coaxial Cable Fuse Fuse “T” Conn. URP-102 or Splitter Point Pad RG-59 Coaxial Cable Power Power Source Source URP-102 Point Pad RG-59 Coaxial Cable URP-102 Point Pad Single Point Pad Multiple Point Pads ...
Page 8
Figure 3 - URP-102 Point Pad™ Functions URP-102 Point Pad Functions Press the ON/OFF button to turn the lights ON or OFF. Press the SPEED button to toggle between High and Low rotation speeds. Press the Right or Left Arrows to rotate the Searchlight in that direction.
Page 9
Figure 4 - URP-102 Point Pad™ Surface Mount Case Figure 5 - URP-102 Point Pad™ Flush Mount Case Y1-03-0138U...
Figure 6 - URP-102 Point Pad™ Surface Mount Case with gasket and Flush Mount Case with gasket SECTION 6 - URC-102 MASTER CONTROLLER Mounting The Master Controller can be mounted in any position near the Searchlight that is protected from the weather. Check in advance that the coax cable from the Point Pad™...
Page 11
Master Searchlight Power Source Function Controller Wire Cable Wire Lead Orange +12 VDC or +24 Power VDC** Blue Ground Ground Yellow Yellow Lamp Power Green Green Lamp Ground White White Down Black Black Right Brown Brown Left Table 1 WARNING: This wire MUST be fused with a 15 amp fuse in the Master Controller's in-line fuse-holder.
Page 12
NOTE: As per the wiring scheme, the ORANGE wire is connected to the Positive terminal and the BLUE wire is connected to the Negative terminal of the power source. CAUTION: Observe polarities when attaching wires! Maximum Cable Length Wire Size 12v System 24v System #8 AWG...
Page 13
To deactivate the XRCiZ™ feature, press and hold the Point Pad™ ON/OFF button for greater than 5 seconds. The Red LED on the URC-102 Point Pad™ indicates that the XRCiZ™ feature is disabled. NOTE: LED feedback is not available when using RCL-100 or URC- 101 Point Pads™.
Page 14
Power Source Fuse Spotlight 12 VDC or 24 VDC Master Controller in-line 15 amp fuse Ground Blue Orange Yellow Lamp Power Green Lamp Ground Spot Up Master White Spot Down Brown Spot Left Black Spot Right 75 ohm TV Coaxial Cable “T”...
APPENDIX B - USER REPLACEABLE PARTS ACR/RCL-100D Figure 9 - Searchlight User Replaceable Parts Item ACR Part Description Quantity Number Number Front Glass HRMK 1300 Front Frame HRMK 2101 Window Weather Strip HRMK 1201 Screw M4x18 HRMK 1600 Washer M408...
Two 55W, quartz-halogen bulbs are provided with your RCL-100D. If they should need replacement, they can be ordered through an ACR dealer or through ACR Electronics. The part numbers are P/N 6001 for 12V units and P/N 6003 for 24V units.
Page 21
Product No. 9282.3 – URP-102 Point Pad™ Secondary Station Installation Kit includes: Description Quantity ACR Part Number Point Pad™, URP-102 with A3-06-2230 Surface Mount case Case, Flush Mount A1-18-1875-2 Gasket, Surface Mount A1-25-0140-1 Gasket, Flush Mount A1-25-0140-2 U Clamp A1-17-1366...
1 (one) year* from date of purchase or receipt as a gift. During the warranty period ACR Electronics, Inc. will repair or, at its option, replace the unit at no cost to you for labor, materials and return transportation from ACR.
EC DECLARATION OF CONFORMITY ACR Electronics, Inc. hereby declares that the following product is in conformity with Directive 2004/108/EC of the European Parliament and of the Council of 15 December 2004 on Electromagnetic Compatibility (EMC Directive). In accordance with the Directive,...