Mitsubishi Electric LAN Control Utility User Manual page 29

11. Web UI (RoomView Connected projectors only)
 Web UI Info screen
When you click [Info] on the control screen, the following screen will appear. This screen shows the information
and status of the currently connected projector. You can go back to the control screen by clicking [Exit].

 Projector Information
The following information of the projector is displayed.
Projector Name:
Location:
Mac Address:
Resolution:
Light Source Hours: Shows the total light usage time. In case of the projectors equipped with a lamp, the
Projector Model:
 Projector Status
The following information on the projector's status is displayed.
Power Status:
Input Source:
Silent Mode:
Error Status:
Shows the projector's name.
Shows the name of the location where the projector is installed.
Shows the MAC address.
Shows the resolution of the video signal being projected.
item name is "Lamp Time".
<Note>
• When the projector's lamp mode is set to Standard, the lamp operation time
shown on this screen may be longer than the actual lamp operation time, in case
of the projectors equipped with a lamp.
Shows the projector's model name.
Shows the projector's power status.
Shows the name of the source currently selected.
Shows the silent mode currently selected. In case of the projectors equipped with a
lamp, the item name is "Lamp Mode".
Shows the following information if an error occurs in the projector.
Message in the [Error Status] box
3: Fan Error
3: Light Source Failure
3: Projector Overheating
2: Temperature Warning
3: Cover Opened
4: Abnormal State Detected
<Note>
• When the projector is in the normal status, the [Error Status] box is blank.
The fan has an error.
The light source has failed to illuminate.
The projector is overheated.
The projector is about to be overheated.
The cover is open.
The projector has an error.
EN-29

Error description