Mitsubishi Electric LAN Control Utility User Manual page 28

11. Web UI (RoomView Connected projectors only)
 Web UI Tools screen
When you click [Tools] on the control screen, the following screen will appear. You can confi gure the settings of
the currently connected projector using this screen. You can go back to the control screen by clicking [Exit].


 Crestron Control
You can confi gure the settings of Crestron controller.
 Projector
You can confi gure the following settings of the projector.
Projector Name:
Location:
Send:
The settings stored in the projector are displayed.
Projector Model:
DHCP:
IP Address:
Subnet Mask:
Default Gateway:
 User Password
To require entry of the password to display the control screen on the computer, select the [Enabled]
checkbox. When this checkbox is selected, you can confi gure the following settings.
New Password:
Confi rm:
Send:
 Admin Password
To require entry of the password to display the Web UI Tools screen, select the [Enabled] checkbox. When
this checkbox is selected, you can confi gure the following settings.
New Password:
Confi rm:
Send:
You can give any name to the projector. (Up to 15 alphanumeric characters.)
You can give any name to the location where the projector is installed. (Up to 32
alphanumeric characters.)
Click this button to accept your settings.
Shows the projector's model name.
When the DHCP setting is On, the [Enabled] checkbox is selected.
Shows the IP address.
Shows the subnet mask.
Shows the default gateway.
Enter a password to display the control screen. (Up to 26 alphanumeric characters.)
Enter the same password as that you entered in the [New Password] box. If the
passwords don't coincide with each other, an error message appears.
Click this button to accept your settings.
Enter a password to display the Tools screen. (Up to 26 alphanumeric characters.)
Enter the same password as that you entered in the [New Password] box. If the
passwords don't coincide with each other, an error message appears.
Click this button to accept your settings.
EN-28

