Registration Of Projector To "Projectorview Global - Mitsubishi Electric LAN Control Utility User Manual

4. Projector registration

4.2. Registration of projector to "ProjectorView Global+"

The procedures to register projectors vary among the foregoing connection examples.
• In connection examples 1 to 4 (where projectors are installed within the same local network), the projectors
within such network are automatically detected and registered. For details, see procedure A below.
• In connection examples 5 and 6 (where projectors are installed via a router), specify the range of the
projectors' IP addresses and then carry out automatic projector search within the range to register projectors.
For details, see procedure B below.
• Up to 200 units of projectors can be registered at the maximum.
• Projectors that have just been registered by the automatic projector search aren't belonging to any group.
When the projectors you registered aren't displayed on the projector list on the main screen, select "All" from
the group select pull-down menu.
Procedure A - For connection examples 1 to 4 (where projectors are installed within the
same local network)
(1) Start up "ProjectorView Global+".
(2) Select "Search Projector" from "Configuration" of the menu bar on the main screen.
• The projectors connected to LAN are searched automatically.
• Some projectors may require you to enter the password when establishing projector connections for the first
time. If the projector password is changed, you need to enter that new password.
<Note>
• Note that a different IP address may be assigned every time you start the projectors. If a connection cannot
be established, execute "Search Projector".
• If you change the IP address in the projector menu after the projectors have been detected, execute "Search
Projector" again.
• If several projectors with the same IP address are registered, delete the ones which are not connected to the
network from "Edit Projector Setting".
EN-11