Mitsubishi Electric XL7000U User Manual page 33

Menu operation (continued)
INSTALLATION menu
INSTALLATION
ON
ITEM
LAMP MODE
STANDBY MODE
AUTO POWER ON
AUTO POWER OFF
IMAGE CAPTURE
SPLASH SCREEN
BACK COLOR
IMAGE REVERSE
LENS LOCK
ZOOM/FOCUS LOCK ON / OFF
LENS SHIFT LOCK
LENS SHIFT RESET
DVI LONG CABLE
LAMP MODE has been set to STANDARD, the lamp mode changes from LOW to STANDARD about 2 minutes after turn-on.
is displayed to the right of the menu bar while the projector is warmed up. While the icon is being displayed, you
cannot change the lamp mode. And an icon
is being displayed, the lamp may not brighten even when you change the LAMP MODE to STANDARD.
SPLASH ID SCREEN to enable the password lock.
may remain on the screen. Consult your dealer in this case.
opt.
LAMP MODE
STANDARD
STANDBY MODE
LOW
AUTO POWER ON
OFF
AUTO POWER OFF
5min
IMAGE CAPTURE
SETUP
SPLASH SCREEN
ON
BACK COLOR
BLUE
IMAGE REVERSE
OFF
LENS LOCK ENTER
DVI LONG CABLE AUTO
SETTING
STANDARD
LOW
STANDARD
LAN
LOW
ON / OFF
OFF / 5min-8hour
SETUP
ON / OFF
BLUE / BLACK /
IMAGE
OFF
MIRROR
INVERT
MIRROR INVERT
ENTER
ON / OFF
OK
AUTO
MANUAL
INSTALLATION
LENS LOCK
ZOOM/FOCUS LOCK
LENS SHIFT LOCK
LENS SHIFT RESET
FUNCTION
Select this option when you want to view images in a well-lit room.
Select to moderate the intensity of the lamp. The operating sound is reduced
and the lamp lifetime becomes longer.
Select this option when you control the projector via the LAN terminal during
power standby. Audio is output from the AUDIO OUT terminal. Video signal is
output from the MONITOR OUT terminal.
Select this option when you control the projector via the LAN terminal during
power standby.
Select this option when you don't control the projector via the LAN terminal
during power standby. This option disables the LAN terminal and reduces the
power consumption during the power standby.
When ON is chosen, the projector is automatically turn on when the power
cord is plugged in the wall outlet. Choose ON when using the projector
mounted on the ceiling.
remote control to turn on the lamp.
When no video signal is input and no operation is made, the projector
automatically turns off after the selected time period. A dialog is displayed 5
minutes before the projector turns off.
Use to capture the screen for the splash screen. (See page 48.)
Choose ON to display the splash screen when the power is turned on.
Use to select the background from among BLUE, BLACK and IMAGE, which
will be displayed when there is no signal input from the source. When IMAGE
is selected, the splash screen will be displayed.
Select when viewing images from the front with the projector installed on the
floor.
Select when viewing images projected from the behind of the screen with the
projector installed on the floor.
Select when viewing images projected from the behind of the screen with the
projector installed on the ceiling.
Select when viewing images from the front with the projector installed on the
ceiling.
The LENS LOCK menu is displayed for the following settings.
Use to enable or cancel the FOCUS LOCK and ZOOM LOCK.
Use to enable or cancel the LENS SHIFT LOCK.
Use to reset the position of the lens to the factory setting.
Select this option for normal use.
Use to adjust the amount of transmission signal correction when a long DVI
cable is used.
is displayed while the operating ambient temperature is high. While the icon
on the icon.
EN-33
opt.
OFF
OFF
OK