Mitsubishi Electric Mr.Slim Zuba Central User Manual page 14

<Setting the Weekly Timer>
5. Press the appropriate Set Time button (11) as necessary to set the desired time (at [5]).
* As you hold the button down, the time first increments in minute intervals, then in ten-
minute intervals, and then in one-hour intervals.
6. Press the ON/OFF button (1) to select the desired operation (ON or OFF), at [6].
* Each press changes the next setting, in the following sequence:
No display (no setting) "ON" < > "OFF"
7. Press the appropriate Set Temperature button (3) to set the desired temperature at [7].
* Each press changes the setting, in the following sequence: No display (no setting)
75 <>77 ... 84<> 87 53 < ...> 73 No display.
(Available range: The range for the setting is 12 °C, 53 °F to 30 °C, 87 °F. The actual
range over which the temperature can be controlled, however, will vary according to the
type of the connected unit.)
8. After making the appropriate settings at Steps 5, 6 and 7, press the Filter button (4) to
lock in the values.
To clear the currently set values for the selected operation, press and quickly release the
Check (Clear) button (10) once.
• The displayed time setting will change to "—:—", and the On/Off and temperature
settings will all disappear.
•
(To clear all weekly timer settings at once, hold down the Check (Clear) button (10) for
two seconds or more. The display will begin blinking, indicating that all settings have
been cleared.)
• Note: Your new entries will be cancelled if you press the Mode (Return) button (2)
before pressing the Filter button (4) . If you have set two or more different operations
for exactly the same time, only the operation with the highest Operation No. will be
carried out.
9. Repeat Steps 3 to 8 as necessary to fill as many of the available cells as you wish.
10. Press the mode (Return) button (2) to return to the standard control screen and complete
the setting procedure.
11. To activate the timer, press the Timer On/Off button (9), so that the "Timer Off"
indication disappears from the screen. Be sure that the "Timer Off" indication is no
longer displayed.
* If there are no timer settings, the "Timer Off" indication will blink on the screen.
Page - 14 - of 23