Mitsubishi Electric NM-C110 Installation And Operation Manual page 25

RTP Setting
Have a setting for sending and receiving an audio or video on a real-time basis.
Stream RTP after Network Camera start-up
Enter a destination IP and Port to send stream automatically through the RTP while
the Network Camera has booting.
Send to DHCP server IP: Send stream to the DHCP server.
Send to (Client) IP: Send stream to other certain destination addresses.
Use RTP destination Port: Available from 1024 to 65532, and the default is 5000.
Do not send: Do not send a stream automatically.
Enable multi stream
Check it to send data for the purpose of saving them into an external extension
storage right after the Network Camera operates.
-Send to secondary client ip: Enter an IP address of the external extension storage.
-Use RTP destination port: Enter a Port number of the external extension storage.
The Port number to be used is [1024 ~ 65532].
-Frame rate: Indicate a frame rate that is sent to the external extension storage when
the multi stream works.
Once the multi stream function is checked, the MPEG profile setting will be changed
to the Advanced Simple Profile.
- 19 -