Meridian 800 User Manual page 60

CONFIGURING THE PREFACE
DVD/CD PLAYER
To select a standard setting
Warning: this procedure will reset any confi guration and
calibration changes you have made.
• Switch off any power amplifi ers that are connected to the 800 and put
any digital speakers into standby.
• Put the DVD/CD player into standby by pressing Off (front panel or
remote).
• Press and hold down Gain+ (under the front panel).
The display shows:
• Keep holding down Gain+ for a further three seconds.
The display shows:
Then after a short delay the display shows the current Type.
For example:
• Press A or V on the front panel to change the Type number.
The display shows:
• Wait for one second, and then put the DVD/CD player into standby by
pressing Off (front panel or remote).
• Switch on again to use the standard settings you have selected.
Setting up the DVD/CD player with other Meridian
equipment
If you are using the 800 with other Meridian equipment, such as the 861
Reference Digital Surround Controller, you should set up the comms with
the following automatic setup procedure:
• Switch all the units to standby.
• Press Clear (remote).
Each unit will display:
The 800 will then be designated as
the controller, and display:
Type in... 3
Type- please wait.
Type 3
Typing, please wait.
Auto
Controller
53