Choosing A Standard Setting - Meridian 800 User Manual

CONFIGURING THE PREFACE
DVD/CD PLAYER
Type
0
1
2
3
4
5

Choosing a standard setting

The DVD/CD player provides several sets of standard settings, called Types,
which confi gure all aspects of the 800 into one of a number of alternative
standard confi gurations.
Types 0 to 5 are factory settings, designed to cater for the most commonly
needed confi gurations of associated equipment.
These standard Types are shown in the following table:
Main output
Channels Bitstream
6 Yes
6 No
2 Yes
6 Yes
6 No
2 No
Choose one of the Types 0, 1, or 2 if you want to connect the auxiliary
output to an alternative input on the main decoder, or to a second zone
with a suitable Meridian decoder.
Choose one of the Types 3, 4, or 5 if you want to connect the auxiliary
output to a non-Meridian decoder or preamplifi er.
Choose one of the Types 0, 1, 3, or 4 if you are connecting the main output
to a multichannel decoder input. Types 1 or 4 can also be used to connect
the main outputs to DSP loudspeakers.
Choose Type 2 to connect the main output to a two-channel decoder such
as a non-DVD-Audio 861 or 568.
Choose Type 5 to connect the main output to a single pair of DSP
loudspeakers or a two-channel preamplifi er.
In addition, your installer may have provided one or more named User
Types, with settings appropriate to the confi guration of equipment when
your 800 was installed.
You can reset the confi guration of the DVD/CD player to any of these Types
to restore it to the state it was in when it was installed. Note: Selecting a
Type will clear any confi guration and calibration changes you have made.
96kHz MHR
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
52
Auxiliary output
Bitstream 96kHz
Yes Yes
Yes Yes
Yes Yes
No No
No No
No No
MHR
Yes
Yes
Yes
No
No
No