Enable Usb Port; Usb Port Emulation Switching; Enable Network Port; Network Port Emulation Switching - Sharp AR-M351N Printer Operation Manual

DESCRIPTION OF SETTING PROGRAMS
Enable parallel port
This program is used to enable or disable printing from
the parallel port.
Default setting: Enable
Parallel port emulation switching
This program is used to specify a printer language to
emulate when the printer is connected to a computer
through the parallel port.
Setting items Description
Auto The printer language will switch
automatically in accordance with the
data from the computer.
PostScript PostScript emulation is used to print
the data from the computer. (An
optional
needed.)
PCL PCL emulation is used to print the
data from the computer.
NOTE
It is recommended to set "AUTO" (default setting)
unless an error due to this setting occurs frequently.

Enable USB port

This program is used to enable or disable printing from
the USB port.
Default setting: Enable

USB port emulation switching

If the machine is connected using the USB port, select
the emulated printer language.
The setting items are the same as those of "Parallel
port emulation switching".
NOTE
It is recommended to set "AUTO" (default setting)
unless an error due to this setting occurs frequently.

Enable network port

This program is used to enable or disable printing from
the network port.
Default setting: Enable

Network port emulation switching

This program is used to specify a printer language to
emulate when the printer is connected to a computer
through the network port.
The setting items are the same as those of "Parallel
port emulation switching".
NOTE
It is recommended to set "AUTO" (default setting)
unless an error due to this setting occurs frequently.
PS3 expansion kit is
Port switching method
The machine can use the three ports shown below for
printing. This program is used to select when switching
between ports will take place. "SWITCH AT END OF
JOB" or "SWITCH AFTER I/O TIMEOUT" can be
selected. When "SWITCH AT END OF JOB" is
selected, the port will be automatically selected after
each print job is completed. When "SWITCH AFTER I/
O TIMEOUT" is selected, the port will be automatically
selected if the time set in the I/O Timeout program
elapses.
G Parallel port
G USB port
G Network port
Parallel port ECP setting
This is used to enable bi-directional communication
through the Centronix interface.
Select "Parallel port ECP setting" to enable data
transmission both from the computer to the printer and
from the printer to the computer.
Normally ECP mode is not selected.
5-6