Sharp PC-AR50 Manual page 87

4. To change the password, type the new password again and press Enter. To
delete the password, just press Enter again.
5. When the confirmation message appears, press Enter.
6. Press Esc and select Exit Saving Changes.
7. Press Enter twice. The system restarts.
Password Requirements
If you have enabled Password on boot in the Security page of the setup utility, the
system will ask for a password when the system starts. If a user password is entered,
then the user has limited access to the floppy disk drive as set by the holder of the
supervisor password.
When the setup utility is opened, a password is required. If a user password is
entered, the user does not get access to some items shown in Supervisor Password
and User Password on the previous page.
Setting a Password for System Stand by/Hibernate Resume
Use the Windows Power Options Properties program to set a password that must be
entered in order to resume the system from a system stand by/hibernate mode. If you
have already installed a Windows password you can skip steps 1-4.
1. From the Start menu, select Settings - Control Panel.
2. Double-click Passwords to open Passwords Properties dialog box. If you
cannot find the icon, click view all Control Panel options to show the icon.
3. Use the Change Passwords tab to install a password for windows.
4. Restart your computer to complete the password installation.
5. Return to the Control Panel. Double-click the Power Options to open the
Power Options Properties dialog box.
6. Click Advanced tab, and check Prompt for password when computer goes off
standby and hibernate.
7. Click Apply and OK.
7
7-3