Fisher-Price POWER WHEELS 78537 Owner's Manual & Assembly Instructions page 15

21
Sport Bar Bracket
Ring
Sport Bar Support
Side Leg
• Using safety scissors, remove the sport bar
brackets from the plastic connector. Dispose of the
plastic connector.
• Position the sport bar upright.
• Position a sport bar bracket onto one of the sport bar
side legs, as shown.
• Fit the ring on a sport bar support against the end of the
sport bar bracket.
• Fold the sport bar bracket over the sport bar to close it
around the sport bar and sport bar support.
22
Sport Bar Bracket
#6 x 1
Sport Bar Support
• Insert a #6 x 1 1 / " screw into the sport bar bracket
2
as shown.
• Tighten the screw with a Phillips screwdriver.
Do not over-tighten.
• Repeat steps 21 and 22 to attach the other sport bar
support to the other sport bar side leg.
Assembly
Sport Bar
Sport Bar
1 / " Screw
2
23
#6 x 1 1 / "
2
Screws
Sport Bar
• Position the sport bar with the ends on a flat surface,
as shown.
• Fit and hold the front and back halves of the KC
rack against the sport bar. Make sure the two KC
rack halves are aligned, and that the screw holes in the
KC TM light rack are aligned with the screw holes in the
sport bar.
• Snap the tabs on the front half of the KC
the slots below the light housings on the rear half of the
KC TM light rack.
• Insert two #6 x1 1 / " screws through the holes in the back
2
of the KC TM light rack, through the sport bar, and into the
front half of the KC
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
24
Housing
• Align the four tabs on the inside of a light cover
with the four slots in one of the light housings on the
KC TM light rack. (Make sure the light covers are
positioned with the wide spaced tabs at the top.)
• Push firmly on the light cover to snap it to the housing.
• Repeat this procedure on the other side of the
15
KC TM light rack to assemble the other light.
KC TM Light Rack - Back Half
Tabs
KC Light Rack -
TM
Front Half
TM light rack into
TM light rack.
Slots
Light Covers
TM light
TM light