Sharp SD-AT1000W Operation Manual page 29

After completing the setting
When the timer setting is completed:
The unit is in the timer playback
stand-by mode.
When the start time is reached:
Playback starts automatically and the volume
increases gradually.
The unit is operated by the timer.
When the finish time is reached:
The unit is set to the power stand-by mode automatically.
The timer setting is canceled.
Caution:
The contents of the setting will be erased if the unit is unplugged or a power failure
occurs. In such cases, set the timer again.
To check the timer setting:
1 Whilst in the timer playback stand-by mode,
press the TIMER button.
2 Within 10 seconds, press the
press the ENTER button.
The unit returns to the timer playback stand-by mode after the setting contents
are displayed in order.
Cancelling the timer playback:
Timer playback is cancelled by turning the power on whilst in the timer playback
stand-by mode. The same operation can be performed in the following procedure
Timer play indicator flashes
without turning the power on.
1 Press the TIMER button.
"TIMER CANCEL" will appear.
2 Within 10 seconds, press the ENTER button.
Timer playback will be cancelled (the contents of the setting will not be cancel-
led).
Reusing the timer:
Using the same setting;
The timer setting will be memorised once it is entered. To reuse the same setting,
perform the following operations.
1 Turn the power on and press the TIMER button.
"TIMER STANDBY" will appear. If it does not appear, set the unit to the correct
time.
2 Within 10 seconds, press the ENTER button.
After the setting contents are displayed in order, the unit is set to the timer
playback stand-by mode.
Changing the setting;
Turn the power on, and repeat the operation from step 1 in "Setting the timer"
(page 27).
04/7/21
or button to select "TIMER CALL", and
SD-AT1000W_LAG_E5.fm
SD-AT1000W
ENGLISH
1
2
3
4
5
6
7
8
E-28
TINSZA121AWZZ