Sharp SD-AT1000W Operation Manual page 27

Step 2. Speaker level setting
If sounds from the speakers are uneven, you can equalise them by adjusting the
speaker levels.
1
Press the AMP SET UP button, and the
LEVEL". Then press the ENTER button.
2
Within 10 seconds, press the or
speaker.
3
Within 10 seconds, press the or
! You can adjust the level at 1 dB intervals.
! To adjust the levels of other speakers, repeat the operation from step 2.
Speaker type
FL Front speaker (Left) - 6 dB to + 6 dB
CT Centre speaker - 6 dB to + 6 dB
FR Front speaker (Right) - 6 dB to + 6 dB
SR Surround speaker (Right) - 6 dB to + 6 dB
SL Surround speaker (Left) - 6 dB to + 6 dB
SW Subwoofer - 10 dB to + 10 dB
Notes:
! If subwoofer sound is distorted, lower the subwoofer level.
! You can also adjust the speaker level of a subwoofer connected to the SUB-
WOOFER PRE OUT socket.
Step 3. Test tone
After adjustments, check the speaker sound by listening to the test tone. (You can
readjust the volume level.)
1
or button to select "SP
button to select the desired
button to adjust the level.
2
Level range Default setting
0 dB
0 dB
Step 4. To end the speaker setting
0 dB
0 dB
When you complete the settings, press the AMP RETURN button
twice.
0 dB
+ 6 dB
Press the AMP SET UP button, and the
"TONE". Then press the ENTER button.
Speakers emit the test tone for 2 seconds in turn, starting with the front speaker
(left).
FL CT
SW SL
Readjust the speaker levels if not equal.
Whilst the test tone sounds, press the or
You can select a speaker by pressing the or
04/7/9 SD-AT1000W_LAG_E4.fm
SD-AT1000W(LAG) TINSZA121AWZZ
SD-AT1000W
ENGLISH
or button to select
FR
SR
button to adjust the level.
button.
E-26
TINSZA121AWZZ
5
1
2
3
4
5
6
7
8