Page Separation And Length Reduction; Reverse Order Printing - Savin 1027 Facsimile Reference Manual

RusC2FaxADEN-F_V4_FM.book Page 90 Monday, August 20, 2001 10:52 AM
Reception Features
Page Separation and Length
Reduction
When the size of a received message
is longer than the paper loaded in the
machine, each page of the message
can be split and printed on several
sheets, or reduced and printed on a
single sheet. For example, this feature
splits the message if the message
length is 20mm or longer than the pa-
per used. The message is reduced if it
is less than 20mm longer. When a
message is split, the split mark (*) is
inserted at the split position and
about 10mm of the split area is dupli-
5 cated on the top of the second sheet.
ABC
Note
❒ Your service representative can
customize this feature with the fol-
lowing settings.
• Reduction
• Print split mark
• Overprinting
• Overprinting length
• Guideline for split
❒ You can adjust the overprinting
and reduction lengths within the
following ranges:
• Guideline for split: 5∼155mm
(5mm steps)
• Overprinting
10mm, 15mm
90

Reverse Order Printing

Normally, received pages are printed
and stacked on the tray in the order
they are received. If you turn this fea-
ture on, the machine will start print-
ing the message from the last page
received.
❒ You can choose whether this fea-
❒ When this feature is on, the first
❒ This feature uses Memory Recep-
length: 4mm,
Note
ture is turned on or off. Set this
with the Initial Setup RX. ⇒ p.131
"Reception Mode"
page will be printed last.
tion.