Initial Scanner Setup; Default Settings - Savin 1027 Scanner Reference

Preparations for Use as a Network Scanner

Initial Scanner Setup

This section explains all required settings and procedures for using the machine
as a network scanner.

Default Settings

2
Settings to use the functions of the machine as a network scanner are listed be-
low. Make correct setting of necessary items.
Important
❒ Items marked (✩) are the minimum required settings for using the machine
as a network scanner. Be sure to set these items before use.
❒ Items marked (❍) should be set if required.
❖ ❖ ❖ ❖ System settings
For information about the explanation of settings, see the System Settings
manual.
Clock timer settings
Interface settings
[Network]
File transfer settings
*1
Settings for use as network TWAIN scanner
*2
Settings for use as network delivery scanner
*3
Settings for use as Document Server
*4
Do not change this setting. It must be left at the factory default value.
*5
Make sure that IP address is set.
12
Settings
Scanner Auto Reset Timer
IP Address
Sub-net Mask
Gateway Address
Access Control
Access Mask
Network Boot
*4
Valid Protocol
Ethernet Speed
Delivery Server IP Address
*5
Resend Interval Setting
Resend Frequency Setting
TWAIN Delivery
*1 *2
❍
✩ ✩
❍ ❍
❍ ❍
❍
❍
❍
❍ ❍
❍ ❍
✩
❍
❍
*3
Store
❍
✩
❍
❍
❍