Roland Atelier AT-90SL Owner's Manual page 24

Max Max Max Max
Min Min Min Min
The confirmation message appears on screen.
fig.00-40.eps
If you touch <Cancel>, the Factory Reset will not be
performed, and you will return to the System screen.
5.
When you touch <OK>, the Factory Reset
operation will begin, and the settings will return
to the factory-set condition.
NOTE
Never switch off the power while this operation is in
progress!
fig.00-40.eps
NOTE
Loading factory default settings will erase any Registrations
currently in the memory of the AT-90SL. To save the
registrations you are currently using, refer to "Saving
Registration Sets to a Floppy Disk" (p. 98).
NOTE
To reset only the User memory (p. 62) to its original factory
settings, refer to p. 78.
Harmony Intelligence
Before You Start Playing
You can also use the following method to return to the
factory-set condition.
1.
Make sure there is no floppy disk in the disk
drive before carrying out the procedure.
2.
Turn down the volume to the minimum level,
then turn off the power.
3.
While holding down the [One Touch
Program] button, press the [Power On] switch
to turn the power on.
fig.00-41
Power On
The following screen appears.
fig.00-40.eps
NOTE
Never switch off the power while this operation is in
progress!
One Touch
Program
Set
23