Fisher-Price JEEP WRANGLER 74020 Owner's Manual & Assembly Instructions page 16

25
KC
#6 x 1 1 / "
2
Screws
Sport Bar
• Position the sport bar with the ends on a flat surface,
as shown.
• Fit and hold the front and back halves of the KC
rack against the sport bar. Make sure the two KC
rack halves are aligned, and that the screw holes in the
KC TM light rack are aligned with the screw holes in the
sport bar.
• Snap the tabs on the front half of the KC
the slots below the light housings on the rear half of the
KC TM light rack.
• Insert two #6 x1 1 / " screws through the holes in the back
2
of the KC TM light rack, through the sport bar, and into the
front half of the KC TM light rack.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
TM Light Rack - Back Half
Tabs
KC Light Rack -
TM
Front Half
TM
TM
TM light rack into
Assembly
26
Housing
• Align the four tabs on the inside of a light cover
with the four slots in one of the light housings on the
KC TM light rack. (Make sure the light covers are
light
positioned with the wide spaced tabs at the top.)
light
• Push firmly on the light cover to snap it to the housing.
• Repeat this procedure on the other side of the
KC TM light rack to assemble the other light.
27
Side
Fender
PULL HERE
• Fit the sport bar and sport bar support legs into the holes
in the vehicle body.
• Push down firmly on a sport bar side leg while pulling
up on the side fender to fit the sport bar into the
vehicle body.
• Repeat this procedure on the other side of the
vehicle body.
16
Slots
Sport Bar
PUSH
HERE
Light Covers