Fisher-Price JEEP WRANGLER 74020 Owner's Manual & Assembly Instructions page 14

18
#8 x 1 1 / "
4
Screws
Slots
Windshield Frame -
Front Half
• Fit the back half of the windshield frame onto the front
half of the windshield frame. Make sure the slots at the
bottom of the two windshield frame halves are aligned.
• Insert ten #8 x 1 1 / " screws into the back half of the
4
windshield frame.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Helpful Hint! Squeeze the two windshield halves together
while tightening the screws.
• Lift the assembled windshield to the raised position.
Assembly
#8 x 1 1
Windshield
Screws
Frame -
Back Half
Slots
19
Short Seat
Belt Strap
/ "
4
End
T-Loops
Slot
Seat
• Turn the seat upside down.
• Insert the fastener end of a short seat belt strap through
the slot near the outer edge of the seat. Make sure the
side of the seat belt with the fastener faces the outer
edge of the seat.
• Pull the short seat belt strap completely through the
slot until the last T-loop at the opposite end of the belt
catches against the slot. You will pull one T-loop through
the slot.
• Repeat this procedure to assemble the other short seat
belt strap.
20
T-Loop
Fastener End
• Insert each fastener end of the long seat belt strap
through a slot in the center of the seat. Make sure the
fasteners face the outer edge of the seat.
• Pull each side of the long seat belt strap evenly through
the slots. Make sure to pull each T-loop through a slot.
• Turn the seat upright.
14
T-Loop (Pull through slot)
Fastener End
Slot
Long Seat Belt Strap