Fisher-Price JEEP WRANGLER 74020 Owner's Manual & Assembly Instructions page 12

10
Steering Wheel
• Fit the steering wheel cap into the center of the steering
wheel with the screw holes aligned.
• Insert two #8 x 1" screws as shown.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
11
Wide Tab
Wide
Notch
Lens Guard
• Fit the wide notch in the side of a headlight lens under
the wide tab on a lens guard.
• Press firmly on the inside of the headlight lens to snap it
into the lens guard.
• Repeat this procedure to assemble the other headlight
lens to the remaining lens guard.
Assembly
12
#8 x 1" Screws
Steering
Wheel
Cap
• Fit the lens tabs on the back of a lens assembly into the
• Press firmly to snap the lens assembly into the grille.
• Repeat this procedure to snap the other lens assembly
13
Lens
• Insert a hood latch into one of the holes in the vehicle
• Twist the base of the hood latch
• Repeat this procedure on the other side of the hood
12
Grille
Slots
Tabs
headlight slots in the grille.
into the grille.
Hood Latch
Hole
body, near the hood area.
the vehicle body.
area to attach the other hood latch to the vehicle body.
Hood
Latch
Hole
1 / turn to secure it in
4