Fisher-Price JEEP WRANGLER 74020 Owner's Manual & Assembly Instructions page 10

2
Battery
Clamp Unit
• Insert two #10 x 1" screws through the holes in the
battery clamp unit and into the pegs in the dash.
3
Battery Clamp
2
• Position the dash on the vehicle body.
• Make sure the motor harness connector wire is through
the groove in the dash.
• Insert a #10 x 1 / " screw through each of the two corner
2
dash tabs nearest to the passenger compartment
• Insert a #10 x 1" screw through the two dash tabs
nearest to the battery compartment
• Insert a #10 x 1" screw into the hole in the center of the
dash, near the battery retainer clip
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Assembly
Dash
Motor
Harness
Connector
Wire
Battery
Compartment
1
.
.
.
10
4
Knobs
• Snap the knobs into the knob plate.
Note: Gently squeeze the tabs on the knobs together
before inserting the knobs into the knob plate.
5
Dash
Key Assembly
Dash View
• Bend the end of the microphone cord so that it forms a "T".
• Insert the end of the microphone cord through the square
opening in the dash pocket. Pull gently on the cord to
make sure it is secure in the dash.
• Hook the microphone onto the "U" slot on the dash pocket.
• Position the bottom edge of the knob plate in the opening
in the dash.
• Snap the top of the knob plate into the dash.
• Snap the key assembly into the dash.
Knob Plate
Knob Plate
Pocket
Microphone
Cord
T-End