Industry Canada; Fcc Statement - Lowrance Broadband 3G Installation Manual

!
2 |
Contents | Broadband 3G/4G™ Radar Installation Guide
Compliance
The Broadband 3G™ and 4G™ Radars comply with the following regulations:
• FCC Part 15.
• Industry Canada RSS-Gen.
• CE compliant with R&TTE directive.
For further compliance information please refer to our websites:
http://www.simrad-yachting.com/Products/Marine-Radars
http://www.lowrance.com/Products/Marine
http://www.bandg.com/Products

Industry Canada

IC: 4697A-3G4G
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.

FCC Statement

FCC IDENTIFIER: RAY3G4G
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
 Note:
This equipment has been tested and complies with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a normal installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. This device must accept
any interference received, including interference that may cause undesired operation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an output on a circuit diff erent from that to which the receiver is
connected.
Consult the dealer or an experienced technician for help.
 Note:
A shielded cable must be used when connecting a peripheral to the serial ports.
Changes or modifi cations not expressly approved by the manufacturer could void the user's
authority to operate the equipment.
Radar Transmit Emissions
 Note:
Broadband 3G™ and 4G™ Radar are the second generation marine recreational radar
from Navico that has Human Exposure Level RF Radiation of the Radar Transmitter outside
the Radome well below the general public safety emission level of 1 mW/cm
radar can be mounted safely in locations impossible with other pulse radars.
 Note:
If a pulse radar and Broadband Radar are mounted on the same vessel, do not transmit
simultaneously as excessive interference is possible.
The Broadband Radar will not trigger X Band radar transponders, beacons, and
SARTs due to the low output power and signal properties.
. This means the
2