Connect The Broadband Radar To Your Display; Lowrance Hds Usa (No Marpa) - Lowrance Broadband 3G Installation Manual

4
14 |

Connect the Broadband radar to your display |

Connect the Broadband radar to your display

Lowrance HDS USA (no MARPA)

1
FUSE
FUSE
_
+
1.
Lowrance HDS
2.
Ethernet adapter cable. 5 pin yellow male to RJ45 female 1.8 ft (6ft). Included in 3G™ kit 000-
10418-001 (Lowrance USA only). Can connect directly to the HDS, or via a NEP-2 Ethernet
switch, or using a free Ethernet port on a LSS-1 Structure Scan module (if applicable)
 Note:
Make sure this connection is made in a dry environment and is secured properly
3.
Broadband 3G™ Radar
4.
Interconnection cable - ships with a 10 m (33 ft): Optional 20 m (65 ft) and 30 m (98 ft)
available
 Note:
To add MARPA and / or chart overlay, you need to add an RI10 Interface Box and Heading
Sensor (see next page)
 Note:
Broadband 4G™ radar may also be connected in this manner, but off ers no advantage as
they are all shipped with an RI10 interface box, which allows connection of a heading source
to the radar
Broadband 3G/4G™ Radar Installation Guide
NEP-2 (Optional)
2
3
2
4