Siemens 2000592-001 User Manual page 38

Establishing a Connection,
Password Format
How to Change
Password
How to Log Out
How to Log On
28 • Data Communications Setup
Continued
A password name can consist of any combination of alphanumeric
characters. The alphanumeric name must have a minimum of five and a
maximum of twenty characters. The ANCB is shipped from the factory
with the word "password" entered as the default password name.
The user can change the password name at any time. To do this login
using the current password then type: "password stand stand". Where
the word stand is your new password entered twice to verify that it was
properly entered.
You may log out or close the Configuration and Diagnostic program at
any time by typing logout. However, the Configuration and Diagnostic
program will automatically log you out after five minutes.
The following procedure assumes that a PC is connected to the ANCB
Configuration port (Figure 4-1), and the PC HyperTerminal program has
been configured to communicate with the ANCB; see Configuring Your
PC, page 22
1. Open Windows HyperTerminal program.
2. Press ↵ Enter twice.
The following dialog box appears:
2000592-001