Fisher-Price FIREROCK 73610 Owner's Manual & Assembly Instructions page 13

12
Wheel
(Indented Side First)
Hubcap
(Pointed Side First)
.437
Cap
Nut
.437"
• Turn the vehicle assembly upside down on a flat surface.
• Fit a washer, bushing (ring side first), wheel
(indented side first) and hubcap (pointed side first)
onto one of the front axles.
• Fit a .437 cap nut onto the end of the front axle.
• Tap the cap nut with a hammer to secure the cap nut on
the front axle. Pull on the cap nut to be sure it is secure.
• Repeat this procedure to assemble the other washer,
bushing, wheel, hubcap and cap nut to the other
front axle.
13
• Turn the vehicle assembly upright.
• Fit the two tabs on the front of the seat into the two
slots in the vehicle body.
Assembly
Washer
Bushing
Front Axle
(Ring Side First)
Bushing
Ring
Side
Seat Tabs
Slots
14
• Insert a #10 x 1" screw through the back of the seat
and into the vehicle body. Tighten the screw.
15
Hole
• Position the roll bar so that it bends toward the back
end of the vehicle.
• Insert and "snap" the roll bar into the large holes in the
top side of the vehicle body, as shown.
• Pull up on the roll bar to be sure it is secure.
13
Seat
Roll Bar
Hole