Stopping The Engine; Operation - Shindaiwa M254 Owner's/Operator's Manual

when the Engine Starts...
■
After the engine starts, allow the
engine to warm up at idle 2 or 3 min-
utes before operating the unit.
Starting A Flooded Engine
1. Slide the ignition switch to the "I" (ON) position.
2. Open the choke, put the throttle trigger in the full throttle position, then clear excess fuel from the combustion chamber by
cranking the engine several times.
3. If the engine still fails to start or fire, refer to the troubleshooting flow chart at the end of this manual.

Stopping the Engine

Idle the engine briefly before stopping
(about 2 minutes), then slide the ignition
switch to the "O" (Engine OFF) position.

Operation

Checking Unit Condition
NEVER operate the unit with the
cutting attachment shield or other
protective devices removed!
Use only authorized Shindaiwa parts
and accessories with your Shindaiwa
unit. Do not make modifications to
this unit without written approval from
Shindaiwa.
ALWAYS make sure the cutting
attachment is properly installed and
firmly tightened before operation.
NEVER use a cracked or warped cutting
attachment: replace it with a serviceable
one.
waRninG!
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from
all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop
before removing obstructions, clearing debris, or servicing unit.
waRninG!
Engine exhaust IS HOT, and contains Carbon Monoxide (CO), a poison gas. Breathing CO can cause uncon-
sciousness, serious injury, or death. Exhaust can cause serious burns. ALWAYS position unit so that exhaust is directed
away from your face and body..
waRninG!
Operation of this equipment may create sparks that can start fires. This unit is equipped with a spark arrestor
to prevent discharge of hot particles from the engine. Metal blade use also can create sparks if the blade strikes rocks,
metal, or other hard objects. Contact local fire authorities for laws or regulations regarding fire prevention requirements.
■
After the engine is warm, pick up the
unit and clip on the shoulder strap, if so
equipped.
Slide ignition to OFF
ALWAYS make sure the cutting attach-
ment fits properly into the appropriate
attachment holder. If a properly installed
attachment vibrates, replace the attach-
ment with new one and re-check.
ALWAYS stop the engine immediately
and check for damage if you strike a
foreign object or if the unit becomes
tangled. Do not operate with broken or
damaged equipment.
NEVER allow the engine to run at high
RPM without a load. Doing so could dam-
age the engine.
■
Advancing the throttle makes the cutting
attachment move faster; releasing the
throttle permits the attachment to stop
moving. If the cutting attachment con-
tinues to move when the engine returns
to idle, carburetor idle speed should be
adjusted (see "Adjusting Engine Idle".).
OFF
NEVER operate a unit with worn or
damaged fasteners or attachment
holders.
waRninG!
A cutting attachment shield
or other protective device is no
guarantee of protection against rico-
chet. YOU MUST ALWAYS GUARD
AGAINST FLYING DEBRIS!
11