Stopping The Engine; Operation - Shindaiwa M242 Owner's/Operator's Manual

Stopping the Engine

Idle the engine briefly before stopping (about 2 minutes), then slide the ignition
switch to the "O" (Engine OFF) position.
Checking Unit Condition
NEVER operate the unit with the cut-
ting attachment shield or other protec-
tive devices removed!
WARNING!
A cutting attachment shield or
other protective device is no guar-
antee of protection against ricochet.
YOU MUST ALWAYS GUARD
AGAINST FLYING DEBRIS!
Use only authorized Shindaiwa parts
and accessories with your Shindaiwa
trimmer. Do not make modifications to
this unit without written approval from
Shindaiwa.

Operation

WARNING!
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from
all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop
before removing obstructions, clearing debris, or servicing unit.
WARNING!
Engine exhaust IS HOT, and contains Carbon Monoxide (CO), a poison gas. Breathing CO can cause uncon-
sciousness, serious injury, or death. Exhaust can cause serious burns. ALWAYS position unit so that exhaust is directed
away from your face and body..
WARNING!
Operation of this equipment may create sparks that can start fires. This unit is equipped with a spark arrestor
to prevent discharge of hot particles from the engine. Metal blade use also can create sparks if the blade strikes rocks,
metal, or other hard objects. Contact local fire authorities for laws or regulations regarding fire prevention requirements.
10
ALWAYS make sure the cutting attach-
ment is properly installed and firmly
tightened before operation.
NEVER use a cracked or warped cutting
attachment: replace it with a serviceable
one.
ALWAYS make sure the cutting attach-
ment fits properly into the appropriate
attachment holder. If a properly installed
attachment vibrates, replace the attach-
ment with new one and re-check.
OFF
251029
Figure 12
ALWAYS stop the engine immediately
and check for damage if you strike a
foreign object or if the unit becomes
tangled. Do not operate with broken or
damaged equipment.
NEVER allow the engine to run at high
RPM without a load. Doing so could
damage the engine.
NEVER operate a unit with worn or
damaged fasteners or attachment hold-
ers.