Table of Contents
Advertisement
F
1
Right Fender
Peg
Bottom View
• Position the vehicle body upside down.
Note: The mudflaps are marked "R" and "L" to designate
right and left.
• With the "R" marking facing up, align the two round
holes in the right mudflap with the pegs on the underside
of the right fender.
3
• Insert two #8 x
/
" screws through the round holes in the
4
mudflap and into the right fender.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
2
Oval Hole
Bottom View
• Align the two oval holes in the right mudflap with the
pegs on the underside of the right fender.
3
• Insert two #8 x
/
" screws through the oval holes in the
4
mudflap and into the right fender.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat steps 1 and 2 to assemble the left mudflap ("L")
to the left fender.
Assembly
Round Hole
Right
Mudflap
Right
Mudflap
3
• Fit a cap nut onto one end of the rear axle.
•Tap the other end of the rear axle with a hammer to
secure the cap nut on the end of the rear axle.
Note: You may want to position the cap nut on a scrap
block of wood to protect the assembly surface.
4
• Slide a hex bushing, ring side first, onto the rear axle.
• Slide a hubcap, ring side first, onto the rear axle.
• Slide a wheel onto the rear axle. Make sure the ribs on
the wheel face up.
• Slide a rear wheel driver, ring side first, onto the rear
axle. Fit the grooves on the rear wheel driver onto the
ribs on the wheel.
•Slide a washer onto the rear wheel axle.
• Set the rear axle assembly aside.
9
Rear Axle
Cap Nut
Washer
Rear Wheel Driver
Wheel
Hubcap
Hex Bushing
Advertisement
Table of Contents
