Table of Contents
Advertisement
1
Thermal
Fuse
Backing
• Install a thermal fuse in each battery:
- Peel the backing from the underside of the plastic
thermal fuse casing and discard the backing.
- Insert the thermal fuse, prong side down, into the
battery. Make sure the prongs are fully inserted into
the battery.
- Press on the plastic casing to be sure it is adhered to
the battery.
Note: The thermal fuses are properly installed in the
batteries when the plastic casings rest squarely on
top of the batteries.
2
Slots
Ribs
Battery
Connector
• Align the ribs on the top of one of the battery
connectors with the slots on the bottom of the other
battery connector.
• Stack the two battery connectors and press to join.
Note: Make sure that the two connectors on the charger
are also stacked and joined.
Battery Charging
Thermal Fuse
Prongs
Battery
Battery Connector
A-Style
3
Charger
Connector
A-Style
Battery Connector
GAP
Incorrect
• Plug the charger and battery connectors together.
Push firmly to make sure the two connectors are
completely joined.
4
• Plug the charger into a standard 120 volt wall outlet.
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is "ON".
• Before first time use, charge the batteries for
at least 18 hours. Never charge the batteries longer
than 30 hours.
• Recharge the batteries for at least 14 hours after
each use of your vehicle. Do not charge the batteries
longer than 30 hours.
• Once the batteries are charged, disconnect the charger
connector from the battery connector. Unplug the
8
charger from the wall outlet. The batteries are now
charged and are ready to be installed in your vehicle.
NO GAP
Correct
Advertisement
Table of Contents
