Medalist sl family ata interface drives (40 pages)
Summary of Contents for Seagate MOMENTUS 5400.3 SATA
Page 1
Product Manual Momentus 5400.3 SATA ® Removable Drive Cartridge 160 GB 100459868 Rev. D August 2007...
Page 2
SeaBOARD, SeaFONE, SeaTDD, and SeaTools are either trademarks or registered trade- marks of Seagate Technology LLC or one of its affiliated companies in the United States and/ or other countries. All other trademarks or registered trademarks are the property of their respective owners.
Introduction This manual describes the functional, mechanical and interface specifications for the 160GB Seagate ® Momentus 5400.3 SATA Removable Drive Cartridge (RDC). These drives provide the following key features: • Reliable--nonrecoverable read error rate of 1 in 10 bits read.
Shadow Register Block. All Serial ATA devices behave like Device 0 devices. For addi- tional information about how Serial ATA emulates parallel ATA, refer to the “Serial ATA: High Speed Serialized AT Attachment” specification. The specification can be downloaded from http://www.serialata.org. Momentus 5400.3 SATA Removable Drive Cartridge Product Manual, Rev. D...
Unless otherwise noted, all specifications are measured under ambient conditions, at 25°C, and nominal power. For convenience, the words and phrases RDC, removable drive cartridge, drive, and this drive are used throughout this manual to indicate the 160GB Momentus 5400.3 SATA Removable Drive Cartridge (RDC). Specification summary The specifications listed below are for quick reference.
Page 10
**Typical notebooks will pull power to the drive when entering S3 and S4; while in the S3 and S4 states, drive sleep and drive standby modes will not contribute to battery power consumption. Momentus 5400.3 SATA Removable Drive Cartridge Product Manual, Rev. D...
Start/stop times ° Max @ 25 Time to ready Typical Power-on to Ready (sec) Standby to Ready (sec) Momentus 5400.3 SATA Removable Drive Cartridge Product Manual, Rev. D...
Standby 0.2 watts Sleep 0.2 watts *During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Momentus 5400.3 SATA Removable Drive Cartridge Product Manual, Rev. D...
10 MHz. Note. Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write current. 2.9.3 Voltage tolerance Voltage tolerance (including noise): 5V ± 5% Momentus 5400.3 SATA Removable Drive Cartridge Product Manual, Rev. D...
Standby mode. In both Idle and Standby mode, the drive accepts all commands and returns to Active mode when disc access is necessary. Momentus 5400.3 SATA Removable Drive Cartridge Product Manual, Rev. D...
Drive cartridge storage 25°C (77°F) max 2.10.4 Altitude Operating –304.8 m to 3,048 m (–1,000 ft to 10,000+ ft) Nonoperating –304.8 m to 12,192 m (–1,000 ft to 40,000+ ft) Momentus 5400.3 SATA Removable Drive Cartridge Product Manual, Rev. D...
Nonoperating random vibration input levels (no hard errors, all axes) • 2.22 Grms (5-500 Hz random), 30 min. each axis • Frequency (Hz): 5-500; Slope (dB/Oct.): Power Spectral Density (PSD) (G /Hz) +/- 6dB: 0.01 Momentus 5400.3 SATA Removable Drive Cartridge Product Manual, Rev. D...
Lead (Pb), in electronic products effective July 2006. A number of parts and materials in Seagate products are procured from external suppliers. We rely on the rep- resentations of our suppliers regarding the presence of RoHS substances in these parts and materials. Our...
Seagate also has internal systems in place to ensure ongoing compliance with the RoHS Directive and all laws and regulations which restrict chemical content in electronic products. These systems include standard operat- ing procedures that ensure that restricted substances are not utilized in our manufacturing operations, labora- tory analytical validation testing, and an internal auditing process to ensure that all standard operating procedures are complied with.
• Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Momentus 5400.3 SATA Removable Drive Cartridge Product Manual, Rev. D...
The removable cartridge drive is designed for insertion into a drive bay within a host enclosure that is specifi- cally-designed to house Seagate Removable Drive Cartridge units. This host enclosure may be a surveillance system, a traditional home PC, office PC, an enterprise server host system, or any other host that supports Momentus 5400.3 SATA Removable Drive Cartridge units.
The drive, as shipped from the factory, is configured to allow you to write to and read from the drive. To write protect the Momentus 5400.3 SATA Removable Drive Cartridge, locate the write protect switch and move the write protect switch to the position shown in Figure 4 below. Existing data on the drive may still be read, but writes will be prohibited as long as the switch is in the write protect (locked) position.
Attachment” specification. Hot-Plug compatibility Momentus 5400.3 SATA drives incorporate connectors which enable you to hot plug these drives in accor- dance with the Serial ATA: High Speed Serialized AT Attachment specification revision 2.0. This specification can be downloaded from http://www.serialata.org. This device requires a COMRESET from the host after a hotplug event.
Page 26
3. There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate backplane configuration. 4. All used voltage pins (V ) must be terminated. Momentus 5400.3 SATA Removable Drive Cartridge Product Manual, Rev. D...
Words 54–58, 64–70 and 88 are valid 0007 Number of current logical cylinders xxxx Number of current logical heads xxxx Number of current logical sectors per logical track xxxx 57–58 Current capacity in sectors xxxx Momentus 5400.3 SATA Removable Drive Cartridge Product Manual, Rev. D...
Page 31
Security erase time 0000 Enhanced security erase time 0000 Master password revision code FFFE Hardware reset value xxxx (see description following this table) Auto acoustic management setting xxxx 95–99 ATA-reserved 0000 Momentus 5400.3 SATA Removable Drive Cartridge Product Manual, Rev. D...
Page 32
Ultra DMA mode 4 is currently active. Ultra DMA mode 5 is currently active. Word 93 1 = 80-conductor cable detected, CBLID above V 0 = 40-conductor cable detected, CBLID below V Momentus 5400.3 SATA Removable Drive Cartridge Product Manual, Rev. D...
Enable read look-ahead (read cache) feature (default). Report full capacity available Note. At power-on, or after a hardware or software reset, the default values of the features are as indi- cated above. Momentus 5400.3 SATA Removable Drive Cartridge Product Manual, Rev. D...
S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status Note. If an appropriate code is not written to the Features Register, the command is aborted and 0x 04 (abort) is written to the Error register. Momentus 5400.3 SATA Removable Drive Cartridge Product Manual, Rev. D...
Seagate Service Centers Presales Support Our Presales Support staff can help you determine which Seagate products are best suited for your specific application or computer system, as well as product availability and compatibility. Technical Support Seagate technical support is available to assist you online at support.seagate.com...
Page 36
Seagate Customer Service Operations (CSO) representative for warranty- related issues. Resellers or end users of drive products should contact their place of purchase or Seagate warranty service for assistance. Have your serial number and model or part number available.