Table of Contents
Advertisement
H
Important Note: Use only a Power Wheels
battery with a Power Wheels
any other battery or fuse will damage your vehicle. Make
sure that you charge the battery for at least 18 hours using
the enclosed Power Wheels
your vehicle for the first time. Charge the battery for at least
14 hours after each use of the vehicle. Never charge the
battery longer than 30 hours. Failure to follow these
instructions may damage your battery and will void your
warranty.
1
Battery
Compartment
• The battery compartment is located under the seat of
your vehicle.
• Using a Phillips screwdriver, loosen the screws in the back
of the seat (the screws will remain in the seat). Remove
the seat from the vehicle body.
2
Slot
Battery
Clamp
Arms
• Locate the battery clamp in the battery compartment.
• Squeeze the battery clamp arms together and pull up.
The battery clamp arms will be released from the slots
in the vehicle body.
Battery Installation
®
Type H 6 volt
®
25 Amp fuse installed. Use of
®
6 Volt charger before operating
Seat
Slot
3
Battery
• Place the Power Wheels
battery compartment as shown.
4
Battery
Connector
Arm
Slot
• Squeeze the battery clamp arms together and lower the
battery clamp over the battery. Be sure the battery clamp
arms fit into the slots in the vehicle body.
• Plug the battery connector and motor harness connector
together. Push firmly to snap the two connectors together.
• Re-assemble the seat to your vehicle.
• Insert the tabs on the front of the seat into the slots
inside the vehicle body.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
25
Battery
Compartment
6 volt battery upright in the
®
Motor
Harness
Connector
Slot
Arm
Advertisement
Table of Contents
