Advertisement

Available languages

Available languages

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Iommi TI15-112 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Laney Iommi TI15-112

  • Page 2 WARNING: When using electrical products, basic cautions should always be followed, including the following: 1. Read these instructions. 2. Keep these instructions safe. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7.
  • Page 3 ATTENTION: L’utilisation de tout appareil électrique doit être soumise aux precautions d’usage incluant: 1. Lire ces instructions 2. Gardez ce manuel pour de futures références. 3. Prétez attention aux messages de précautions de ce manuel. 4. Suivez ces instructions. 5. N’utilisez pas cette unité proche de plans d’eau. 6.
  • Page 4 ACHTUNG: Beim Einsatz von Elektrogeräten müssen u.a. grundlegende Vorsichtsmaßnahmen befolgt werden: 1. Lesen Sie sich diese Anweisungen durch. 2. Bewahren Sie diese Anweisungen auf. 3. Beachten Sie alle Warnungen. 4. Befolgen Sie alle Anweisungen. 5. Setzen Sie dieses Gerät nicht in der Nähe von Wasser ein. 6.
  • Page 5 CUIDADO: Cuando use productos electrónicos, debe tomar precauciones básicas, incluyendo las siguientes: 1. Lea estas instrucciones. 2. Guarde estas instrucciones. 3. Haga caso de todos los consejos. 4. Siga todas las instrucciones. 5. No usar este aparato cerca del agua. 6.
  • Page 7: Specifications

    Loudspe aker Custom designed HH acoustic 12" driver Loudspeaker Outputs 8 Ohms, 16 Ohms Input Impedance 1M Ohm/47pF Handle s Yes - Laney Strap Handle Size 445*461*268 (H*W*D) Unit Wei ght 14.8Kg Packed Weight 16.8Kg This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference and (2) this device must accept any received , including interference that may cause undesired operation.
  • Page 9 Black Sabbath – the guitarist was Tony Iommi and the distorted diminished 5 sound was a Laney LA100BL. Since this auspicious day Laney’s association with Tony Iommi has gone from strength to strength resulting in multiple signature models over a span of 20 years including the original GH100TI, and the newly introduced TI100.
  • Page 10: Front Panel Controls

    FRONT PANEL CONTROLS 15W INPUT: 1/4" mono jack socket. Connect your guitar here to get full volume output. Use only high quality guitar cable. <1W INPUT: 1/4" mono jack socket. Connecting your guitar here switches the output stage to under 1W. This allows you to drive the output stage hard at bedroom volume levels.
  • Page 11 FRONT PANEL CONTROLS VOLUME: Controls the volume of the amplifier. Experiment with different combinations of the Drive and Volume controls to achieve different sounds. Reducing the Drive while increasing the Volume will result in a warm, open, overdriven sound as the power amp is driven harder, while reducing the Volume and increasing the Drive will give a tighter, more modern sound with more distortion.
  • Page 12: Rear Panel Controls

    REAR PANEL CONTROLS L Z B 1 2 3 4 Spare fuse located in the fuse drawer. MAINS INLET SOCKET: Make sure the voltage indicated on the rear panel is correct for your country! MAINS FUSE: This drawer contains the main safety fuse for the unit. The fuse protects the amplifier from damage in the event of fault by disconnecting the mains power supply.
  • Page 13 FOOTSWITCH SOCKET: Use a mono tip-switched footswitch (such as the Laney FS1) to enable the Pre-Boost circuit. Note: The Pre-Boost switch on the front panel must be set to O, in order to use the footswitch.
  • Page 14: Quick Start Settings

    QUICK START SETTINGS CLEAN CRUNCH LEAD METAL...
  • Page 15: User Settings

    USER SETTINGS...
  • Page 16 TUBE AMP TIPS Tube amplifiers generally sound much warmer/sweeter than solid state transistor amplifiers but they also need a little more respect due to the fragile glass tubes. The TI15-112 uses three 12AX7 preamp tubes, and 2 EL84 output tubes which should give you years of trouble free service, however like all tube amps;...
  • Page 17: Block Diagram

    BLOCK DIAGRAM FX SEND FX RETURN INPUT <1W DRIVE VOLUME Pre-Boost DI OUT BYPASS 0dBu MUTE -10dBu PHONES FOOTSWITCH CD/MP3 IN (3.5mm) 16Ohms 8Ohms DYNAMICS TONE POWER EXTERNAL LOUDSPEAKER 8-16 OHMS...
  • Page 18: Sample Setup

    Disconnect the internal loudspeaker when using an external cabinet L Z B 1 2 3 4 RECORD OUT TI412S www.laney.co.uk Input Link Power Rating 120W Serial Number: 16 Ohms L Z B 1 2 3 4 Made in the UK by Laney Tony Iommi...
  • Page 19 NOTES...

Table of Contents