Adjusting The Volume; Turning The Power Off; Switching The Output Destination; Using Batteries - Korg Wavedrum mini Owner's Manual

Getting ready to play

Adjusting the volume

• Turn the VOLUME knob toward right to
increase the volume, or toward the left to lower
the volume.
The VOLUME knob controls the output of the
built-in speaker, the headphone jack, and the OUT-
PUT jack.
After you've adjusted the volume to an appropriate
level, try playing the WAVEDRUM Mini. For
details, refer to "Performing" (See page 11).

Turning the power off

When you've finished performing, turn the power
off.
1. Lower the volume by turning the WAVEDRUM
Mini's VOLUME knob all the way to the left.
2. Hold down the power switch for approximately
one second; the power will turn off.
Auto power-off function
The WAVEDRUM Mini's auto power-off function
will automatically turn off the power approximately
four hours after the last panel operation was per-
formed.
If desired, you can disable the auto power-off func-
tion. See page 14 for details.
By default, the auto power-off function is enabled.

Switching the output destination

Your monitor equipment might be damaged if
high volume sound is suddenly output from the
WAVEDRUM Mini. This could also damage
your hearing if you're listening through head-
phones. Please use caution when setting the
volume.
Using headphones
If you're using headphones, connect them to the
headphone jack. If headphones are connected,
sound won't be output from the built-in speaker.
You can use headphones when you don't want to
disturb others around you, such as at night. Insert
the plug of your stereo headphones into the head-
phone jack located on the right side of the WAVE-
DRUM Mini.
8
If you're using headphones with a 1/4" mini adapter
plug, be sure to grasp the adapter when inserting or
removing the plug.
To protect your hearing, avoid listening at high
volume for extended periods of time when
using headphones.
Connecting to an audio device
Connect the WAVEDRUM Mini's OUTPUT jack to
the input jack of your mixer or powered monitor.
The output signal is monaural. If a cable is con-
nected to the OUTPUT jack, the built-in speaker
will be muted.
Before plugging anything in, be sure to power-
off the WAVEDRUM Mini and the device
that's being connected. If you connect the
WAVEDRUM mini to other devices while it's
powered-on, you might damage the WAVE-
DRUM Mini, the other device or malfunctions
might occur. In addition, be sure that the vol-
ume is lowered on all connected equipment.
OUTPUT jack
Headphone jack
INPUT
Headphones
Powered monitor, etc.

Using batteries

Detach the battery cover located on the bottom of
the WAVEDRUM Mini, and install six nickel-metal
hydride batteries, making sure that they are ori-
ented in the correct polarity.
note: Batteries are not included. You'll need to
obtain them separately.
Disconnect the AC Adapter's DC plug before
you install or replace the batteries.
Do not mix charged batteries with exhausted
batteries, and do not mix batteries of different
types.