Consumer Information WARNING To prevent serious injury or death: • Fall Hazard - It is dangerous to use this reclined cradle on an elevated surface, since child's movement may cause the product to slide or tip over. Use only on a fl oor. •...
Page 3
IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price replacement parts and instructions if needed. Never substitute parts.
Page 4
Side Rail Hole Vibrations Unit Front Tube • Locate the hole in each side rail. • With the vibrations unit facing forward, fit the front tube to the side rails, as shown. Hold the front tube in place and proceed to step 6. •...
Page 5
• Fit the upper pocket on the pad onto the seat back tube. • Fasten the pad buckles around each side rail. Assembly Pad Slot Seat Back Tube Hardboard Side Rail • Turn the hardboard over and insert it into the slot in the front edge of the pad.
Battery Installation Hint: We recommend using alkaline batteries for longer battery life. 1,5V “D” (LR20) • Locate the battery compartment on the bottom of the vibrations unit. • Loosen the screw in the battery compartment door. Lift to remove the battery compartment door. •...
Page 7
• Rotate the kickstand out. • Push down on the seat bottom to be sure the kickstand is in position. Restraint Belt Restraint Pad • Place your child in the seat. Position the restraint pad between your child’s legs. • Fasten the restraint belts to each side of the restraint pad. Make sure you hear a “click”...
Page 8
Storage Small Slot • Insert the restraint belts back through the small slots in the pad. • Insert the restraint pad down through the large slot in the pad. • Turn the rocker face down. • Tuck the ends of the restraint pad underneath the buckles, as shown. •...