Table of Contents
Advertisement
2 - 8 Space Between Feed dog and Hole of Needle Plate
Checking:
1. Set stitch length control at maximum.
2. Confirm feed dog does not touch with to needle plate.
3. Confirm feed dog is parallel to needle plate hole.
4. Check to see if clearance (a) is about 1.0 mm, when feed dog shifts to the
front end by turning hand wheel.
Adjustment:
1. Remove face cover and needle plate.
2. Loosen screw (1) of feed dog and adjust the position.
3. Tighten screw (1) firmly after adjustment.
( 1 )
( 1 )
( 1 )
( 1 )
( 1 )
SECTION
2 - 8
PAGE
1
a a a a a
Hide quick links:
Advertisement
Table of Contents
