Janome TB-12 Instruction Book page 22

x
c
n
m
,
z
v
b
16
• Winding the Bobbin
z While holding the handwheel with your left
hand, turn the stopmotion knob in the
direction of arrow.
x Draw the thread from spool.
Pass the thread through the topcover thread
guide.
c Guide the thread around the bobbin winder
thread guide.
v Insert the thread through the hole in the
bobbin from the inside to the outside.
Put the bobbin on the bobbin winder spindle.
b Push it to the right.
n With the free end of the thread held in your
hand, depress the foot control.
Stop the machine when it has made few
turns, and cut the thread close to the hole in
the bobbin.
m Depress the foot control again.
When the bobbin is fully wound, stop the
machine. Return the bobbin winder spindle to
its original position by moving the spindle to
the left, and cut the thread.
, Tighten the stopmotion knob to engage the
clutch.
Note:
Return the bobbin winder spindle when the
machine stops.